Advertisement
Available languages
Available languages
Activating / deactivating the
display illumination and
projection
You can activate the display illumination and the
projection by pressing a key, generating a noise
(e.g. a hand clap) or touching the device at any
place (acoustic and contact function).
Slide the S / C switch
Activate the display illumination by pressing a key,
generating a noise or touching the device at any
place. The display illumination switches on for 5
seconds and then automatically switches off.
In addition, slide the projection switch
ON position.
Activate the projection by pressing a key,
generating a noise or touching the device at any
place. The projection switches on for 20 seconds
and then automatically switches off.
Deactivate the projection by sliding the projection
switch
27
to the OFF position.
Deactivate the acoustic and contact function by
sliding the S / C switch
Adjusting the projection
sharpness, angle and direction
Rotate the projection objective
projection direction (forwards / backwards) by
using the adjustment wheel
Rotate the sharpness control wheel
the projection sharpness.
Press the projection direction button
projection direction through 180°.
16
GB
78346_silv_Projektions-Funkwecker_Content_SE_SI_01.indd 16-17
25
to the ON position.
27
to the
25
to the OFF position.
to the desired
18
(see Fig. E).
29
to adjust
19
20
to turn the
Display temperature in °C / °F
The current interior temperature will be displayed in
the LC display.
Press the - / C / F / RCC key
and forth between the Celsius and Fahrenheit
temperature scale settings
Setting the time zones
During stays in countries in which a DCF radio signal
can be received but are located in other time zones,
the corresponding time tone can be established.
For example, in a country in which the local time is
one hour behind Central European Time (CET), you
may set the 2nd time zone to -01. The clock time
continues to be controlled through the DCF radio
signal, but indicates an hour earlier.
Press the + / 12 / 24 key
the 2nd time zone appears on the LC display.
Press the SET key
21
and hold for about 2
seconds. The "00" hour display flashes.
Press the + / 12 / 24 key
key
24
to set the desired value.
Press the SET key
21
to confirm your entry.
To return from the 2nd time zone to the normal
time display
1
, press the + / 12 / 24 key
hold for about 2 seconds. The F symbol goes out.
Displaying summer time
The summer time is automatically displayed in the LC
display by the summer time symbol
to switch back
24
.
1 1
until the symbol F for
23
23
or the - / C / F /RCC
23
and
5
.
GB
17
8/5/12 2:21 PM
Advertisement
Chapters
