Starter/Generator; Removal - Toro Workman GTX Service Manual

Starter/Generator

3
200 to 230 in- lb
(23 to 25 N- m)
11
17 to 22 ft- lb
(24 to 29 N- m)
25 to 31 ft- lb
(34 to 42 N- m)
200 to 230 in- lb
(23 to 25 N- m)
16 to 20 ft- lb
(22 to 27 N- m)
RIGHT
FRONT
1. Engine
2. Swing arm
3. Primary clutch
4. Secondary clutch
5. Starter/generator belt
6. Starter/generator
IMPORTANT: Torque tighten the fasteners based on
the fastener grade. Make sure to use the correct
torque; refer to Figure 35.
Removal (Fig. 35)
1. Park vehicle on a level surface, stop engine, engage
parking brake and remove key from the key switch.
Place vehicle shift lever in the NEUTRAL position.
Electrical System
4
5
13
8
12
14
18
9
17
7
15
10
Grade 8
200 to 230 in- lb
Grade 5
(23 to 25 N- m)
7. Flange head screw (2 used)
8. Washer
9. Flange nut (7 used)
10. Starter/generator bracket
11. Nut
12. Lock washer
16
7
6
9
Figure 35
2. Raise cargo bed and secure with prop rod to gain ac-
cess to the starter/generator.
3. Remove rear frame panel cover from rear frame to
allow access to starter generator (see Rear Frame Pan-
el Cover in the General Information section of this chap-
ter).
Page 5 - 30
1
9
13. Starter/generator pulley
14. Woodruff key
15. Flange head screw
16. CVT drive belt
17. Carriage screw (4 used)
18. Flange head screw
Workman GTX Gasoline
2
v