Toro Workman GTX Service Manual page 151

3. Chock front wheels. Use a jack to raise rear wheels
off the ground. Support vehicle with appropriate jack
stands beneath the rear frame.
4. Support transaxle from below to prevent the
transaxle and swing arm from moving during rear sus-
pension disassembly.
CAUTION
If stabilizer bar bracket (item 3) or sway bar link
bracket need to be removed, make sure that
transaxle is supported from below.
5. Remove rear suspension components as needed
using Figure 35 as a guide.
A. Check for wear in bushings in panhard rod as-
sembly and replace bushings and or spacers if nec-
essary (shown in Fig. 39).
6. Inspect suspension components for wear or damage
and replace parts as needed.
7. If necessary, remove rear shock absorber(s) (Fig.
38):
A. Remove flange head screws and lock nuts that
secure shock absorber(s) to rear frame and swing
arm.
B. Remove shock absorber(s) from vehicle.
NOTE: On Workman GTX vehicles, rear shocks should
be set to lowest pre--load setting.
NOTE: Use spanner wrench TOR6010 (see Special
Tools in this chapter) if rear shock spring pre--load re-
quires adjustment. If the spring is to be removed from
the shock absorber, shock spring compressor tool
TOR6015 (see Special Tools in this chapter) can be
used.
Assembly (Fig. 35)
IMPORTANT: During assembly of rear suspension
components, install all components before fully
tightening fasteners.
1. Install all removed rear suspension components us-
ing Figure 35 as a guide. After all parts have been in-
stalled fully tighten fasteners to secure suspension to
vehicle. Torque fasteners to specifications listed in Fig-
ure 35.
Workman GTX Gasoline
2. Install rear shock absorber(s) if it was removed (Fig.
38):
A. Position shock absorber(s) to rear frame and
swing arm brackets.
B. Secure shock absorber(s) to vehicle with flange
head screws and lock nuts. Torque screws from 77 to
95 ft- -lb (105 to 128 N- -m).
3. Lower vehicle to ground and lower cargo bed.
5
3
5
4
1. Rear frame
2. Swing arm
3. Shock absorber
2
1. Panhard rod
2. Spacer (2 used)
Page 6 - - 39
77 to 95 ft- -lb
4
(105 to 128 N- -m)
1
3
2
Figure 38
4. Flange head screw
5. Lock nut
1
3
Figure 39
3. Bushing (2 used)
Chassis