Huawei SUN2000-2KTL-L1 User Manual page 55

SUN2000-(2KTL-6KTL)-L1
User Manual
● During the installation of the SUN2000 and battery, the positive or negative
● The cabling distance between the battery and the SUN2000 should be less than
Procedure
Step 1 Assemble the positive and negative connectors by referring to
Input Power
● The battery voltage will result in serious injury. Use dedicated insulation tools
● Ensure that cables are correctly connected between the battery terminal and
Cables with high rigidity, such as armored cables, are not recommended as battery
cables, because poor contact may be caused by the bending of the cables.
Step 2 Insert the positive and negative connectors into corresponding battery terminals
on the SUN2000.
After the positive and negative connectors snap into place, pull the battery cables
back to ensure that they are connected securely.
Issue 04 (2021-04-01)
NO TICE
terminal of the battery will be short-circuited to ground if power cables are not
installed or routed as required. In this case, an AC or DC short circuit may occur
and damage the SUN2000. The caused device damage is not covered under any
warranty or service agreement.
or equal to 10 meters, and within 5 meters is recommended.
Cables.
D ANGER
to connect cables.
the battery switch, and between the battery switch and the SUN2000 battery
terminal.
NO TICE
NO TICE
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connection
5.6 Connecting DC
49