Bosch GLM400CL Operating/Safety Instructions Manual page 24

further measurement, repeat this process.
With the laser beam continuously switched on and in the the
continuous measurement function, measurement will begin
after the measuring button 2 [ ] is pressed for the first time.
Do not point the laser beam at persons or animals and
do not look into the laser beam yourself, not even from a
large distance.
Note: The measured value typically appears within 0.5 s and
no later than approx. 4 s. The duration of the measurement
depends on the distance, the lighting conditions and the
reflective properties of the target surface. Upon completion of
the measurement, the laser beam is automatically switched
off. The continuously switched-on laser beam is not switched
page 25).
You can choose between four different reference levels for
the measurement:
– the rear measuring-tool edge (e.g. when measuring onward
– the tip of the 180° folded-out measuring pin 8 (e.g. when
– the front measuring-tool edge (e.g. when measuring
– the center of thread 17 (e.g. for tripod measurements).
Folding out and in of the measuring pin 8 by 180° is detected
automatically and the appropriate reference level is
suggested. Confirm the setting by pressing the measuring
button 2 [ ].
Use the soft key 3 [
measuring tool. Use buttons 4 [+] or 11 [–] to select the
reference level and confirm this by pressing button 13 [Func].
The rear edge of the measuring tool is automatically preset
as the reference level every time the measuring tool is
switched on.
24
1.800.561.8187
Selecting the Reference Level (see figure A)
from a wall),
measuring from a corner),
onward from a table edge),
www.
] to select the basic settings for the
.com
information@itm.com