Bosch GLM400CL Operating/Safety Instructions Manual page 42

42
1.800.561.8187
Cause
Battery charge indicator (g), temperature warning and
"ERROR" indicator in the display
Temperature of
measuring tool not within
the allowable charge-
temperature range.
Battery charge-control indicator (g) and "ERROR"
indication in the display
not correct
Measuring result not plausible
The target surface does
not reflect correctly (e.g.
water, glass).
Laser beam output 19,
reception lens 20 or
camera 18 is covered.
Wrong reference level
set.
Obstruction in path of
laser beam.
Data transmission via USB interface not possible
www.
Corrective Measure
the Wait until
temperature range is reached.
Check if the plug-in connection
has been established correctly
and if the battery charger is
operating properly. When the
unit symbol is flashing, the
battery is defective and must be
service.
Cover off the target surface.
reception lens 20 and camera
18 clear.
Select reference level that
corresponds to measurement.
Laser point must be completely
on target surface.
Check the proper and tight seating
damage.
.com
the charge-
19,
information@itm.com