Table of Contents
Advertisement
1-6. Rack Mounting
. Mounting in rack
c
Be sure to carry the unit by the two persons or more.
17. Slide each ball retainer of intermediate rails on both
sides (left and right) in the direction of the arrow.
Ball retainer
18. Pull equal length of each rail on both sides out.
19. Lift the unit holding the handles, slowly insert the
inner rails into the intermediate rails.
20. While pressing each stopper of inner rails on both
sides, slowly push the unit into the rack.
n
Be careful not to catch your finger or hand in rack
mount rail.
Stopper
Inner rail
1-8
Intermediate rail
Intermediate rail
Stopper
21. Slide the unit in and out from the rack about three
times and check that the slide rails move smoothly.
If they are not smoothly, demount the unit and go back
to "Attaching the outer rails" (step 12).
c
When demounting the unit, carry it by the two persons
or more.
n
This unit does not have the feet at this operating.
Put down this unit on the floor or other, being careful
not to damage the unit.
22. Secure the unit to the rack with two screws and two
ornamental washers.
Tightening torque: 120 x 10
Ornamental washer
RK5 x 14
RK5 x 14
_2
N . m {12.2 kgf . cm}
Ornamental washer
DNW-A22/A22P
Advertisement
Table of Contents
