Epson TM-C3500 Series Developer's Manual page 50

Paper type
Form
Paper width
Black mark width
Black mark length
Black mark center position
Black mark interval
Paper thickness
Perforated line interval
Perforated line form
Number of folds
• Paper with holes or cutouts cannot be used.
• When fanfold paper is used, the black marks must be at least 0.5 mm away
• Set the auto cut position of fanfold paper to a position 0.5 to 1 mm away
c
IMPORTANT
• Use uncut perforations on both sides of the paper.
• Make sure the position of the black marks is kept the same in relation to
Plain paper / matte paper
Fanfold paper
50 to 108 mm
13 mm or more
4 mm or more (margin part 4 mm or more)
8.5 ± 1 mm
8 to 304.8 mm
0.124 to 0.128 mm
203.2 to 304.8 mm
Plain paper label: 1 mm uncut, 5 mm cut
Matte paper: 1 mm uncut, 5 mm cut
500 or less
from the perforated lines.
behind the perforated line.
the perforated lines (position in which can be detection by the black mark
sensor) when inserting paper from either direction to ensure paper can be
used even if inserted in the reverse direction.
50