Epson TM-C3500 Series Developer's Manual page 87

Roll Paper Handling
Paper formats that can be handled are as follows.
• Continuous paper (black marks)
• Die-cut labels (black marks)
• Die-cut labels (gaps)
• Die-cut labels with transparent backing paper
Paper Handling Procedures
• Continuous paper (black marks) and die-cut labels (black marks)
Set a margin of 107.5 mm or more between the end edge of the paper and the end edge of the
final ticket or label printed. Do not set the label so that it is located less than 107.5 mm from the
end edge of the paper. This area must only consist of backing paper. Affix two black marks
behind the final ticket or label printed.
Q
NOTE
Continuous paper (black marks)
Paper feed direction
Die-cut labels (black marks)
Paper feed direction
If new print data is sent to this printer after print processing (including auto
cut) of the final ticket or label has completed normally, a Media Size Error
will occur, and the printer will stop with the print data retained.
Max. 11 mm
5 ±0.5 mm
107.5 mm or more
End edge of last label
Max. 11 mm
5 ±0.5 mm
107.5 mm or more
End edge of last label
Roll paper core
Roll paper core
87