Table of Contents
Advertisement
Pipes
Delivered
Materials
Cables
Humidifier
water inlet
pipe
Auto-
drainpipe
Purchased
Water
Materials
inlet and
(Mandatory)
outlet
pipes
Cable,
base, and
other
materials
Model
Cable Name
NetCol5000-
Common power cable
C030H7 with
heater and
humidifier
Standby power cable
NetCol5000-
Common power cable
C030H7 without
Standby power cable
heater and
humidifier
NetCol5000-
Common power cable
C030H6
Standby power cable
Condensate drainpipe, hose clamp and pagoda connector on main chilled
water pipes
Corrugated pipe for cabling, OT terminal, cord end terminal, 10 m cable of
network cable for teamwork (Silkscreen is W11), cabinet exterior humidity
and temperature sensor and its cable (Silkscreen is W12, 1 PCS in
standard delivery), cable tie
•
Connects to rigid pipe: BSPT 3/4 inch threads connects to a rigid pipe,
rigid pipe (PPR pipe or galvanized pipe)
•
Connects to hose: Hose (Inner diameter of 3/4 inch; made of EPDM or
other material)
DN19 rubber hose, or PPR pipe with BSPT 1/2 inch outer screw thread
elbow
Copper gate valve (each for the main chilled water supply and return pipes,
above 2.0 MPa resistance), Y-shaped strainer (above 2.0 MPa resistance,
20 openings), water pressure gauge, gauge bend, thermometer
•
Recommended pipe when the NetCol520 is connected: rubber hose
DN25
•
Recommended pipe when the NetCol520 is not connected: rubber hose
DN25, galvanized steel pipe DN25, PPR pipe DN32 (inner diameter ≥
25 mm)
Power cable (as shown in the following table), remote shutdown cable
(optional, 22 AWG), equipotential ground cable (≥ 6 mm
as shown in the following figure), pipeline support, thermal insulation foam,
glue for wrapping thermal insulation foams, black rubber adhesive
with thermal insulation foams, joint sealant
Requirements
Power
to the
indoor
unit
Power
to the
indoor
unit
3
2
), base (optional,
2
3x6.0 mm
Power to
the
equipme
nt room
2
3x2.5 mm
Power to
the
equipme
nt room
Advertisement
Table of Contents
