Download Print this page
Sealey VS270 Quick Start Manual

Sealey VS270 Quick Start Manual

Multi voltage glow plug tester

Advertisement

Quick Links

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions
protection
1. safety
warNiNg! ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
Maintain tester in good and clean condition for best and safest performance.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
9
Wear suitable clothing to avoid snagging. Do Not wear jewellery and tie back long hair.
9
Account for all tools and parts being used and Do Not leave any in or near the engine.
9
Do Not use tester if damaged.
8
Vehicle should be in a well ventilated area.
9
iMPortaNt: These instructions are provided as a guide only. Always refer to the vehicle manufacturer's service instructions, or a
proprietary manual, to establish the current procedure and data.
warNiNg! The warnings referred to in this guide cannot cover all possible conditions and situations that may occur. It must be
understood that common sense and caution are factors which cannot be built into this product, but must be applied by the operator.
2. iNtroDuctioN
designed to test low voltage glow plug operation on modern diesel engines. Prevents glow plug damage caused by testing with the vehicle
battery. Glow plugs can be tested whist in situ. Supplied in storage case with instructions. Requires 9V battery (not supplied).
3. oPeratioN
3.1.
To fit the battery remove rubber case, the battery compartment is located on the base of back of the unit.
3.2.
Multi Voltage glow Plug tester
3.2.1.
Many modern diesel engines have low voltage glow plugs fitted, this type of glow plug cannot be tested using the vehicle battery
voltage as damage may occur.
© Jack Sealey limited
Multi Voltage glow Plug tester
Model no:
Wear protective
Wear safety
gloves
footwear
Original Language Version
Vs270
Wear protective
clothing
VS270 Issue 1 06/11/19

Advertisement

loading

Summary of Contents for Sealey VS270

  • Page 1 Vs270 Model no: thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 Battery reMoVal Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey ltd Batteries Producer Registration number (BPRn) is BPRn00705.