Toro ProPass 200 Installation Instructions Manual page 5

1. Hitch tube
22. Adjust the engine mount bracket so that it is
tight to the hitch. Fully tighten the two bolts
securing the engine mount brackets to the
engine mounting plate
23. Check that the engine mounting plate is level
and fully tighten the 2 bolts (1/2 x 5 inches)
through the engine mount bracket lower holes.
24. Place the battery onto the battery tray,
positioning the terminals as shown in
25. Position the battery hold down on the battery
(Figure 8).
26. Hold the battery mount strap around the
underside of the hitch tube
27. On the right side, install a battery bolt through
the washer, battery mount strap, engine mount
plate, battery tray and hold down. Loosely install
a flange nut (Figure
Note:
Make sure the bolts are installed from
the bottom.
28. On the left side, install a battery bolt through
the washer, battery mount strap, engine mount
plate, battery tray, battery bolt tube, and hold
down. Loosely install a flange nut
29. Make sure everything is concentric and tighten
the nuts
Figure 7
2. Mounting bolts (2)
(Figure 8).
Figure
(Figure 8).
8).
(Figure
g013860
8.
1. Battery bolt (2)
2. Washer (2)
3. Bolt tube
30. Unpack the hose guide, hydraulic return hose
(hose #3), hydraulic suction hose (hose #4), 4
bolts (1/4 x 3/4 inch) and 4 locknuts (1/4 inch).
8).
Note:
guide, hydraulic return hose and hydraulic
suction hose for shipping.
31. Using 2 bolts (1/4 x 3/4 inch) and flange
locknuts, attach the hose guide to the bracket
on the hydraulic tank
5
Figure 8
4. Battery mount strap
5. Flange locknut (2)
Remove the hose secured to the hose
(Figure 9).
g013862