Sharp VH-25 Series Operator's Manual page 36

4. Convertion from vertical to horiziontal milling :
a. Use an open-mouth spanner to loosen the four nuts（E）.
b. Push the ram manually and the turret by 180 degrees until the zero position aligned at the
marking. Then, insert the taper pin（G）to secure the positioning. Lock up the four lock
nuts （E）.
c. Install the cutter shank arbor（F）and lock the upper taper shank by using draw bar（H）.
d. Inser the separating sleeve into the proper position and install the cutter shank arbor
）.Then, repeat it for （I
bracket（I
1
e. Lock tightly the upper nut（K）.
Note: Reverse the steps in the conversion from horizonmtal to vertical milling.
）.insert the remaining sleeves. Lock the nut（J）.
2
Fig.37
Fig.38
OPERATOR'S MANUAL
P 33 / 57