Panasonic AU-EVA1 Manual page 21

Tally
With the default configuration "Panasonic AU-EVA1" for the RCPv2 tally will be enabled on the camera
from the DB9 connector (EXT I/O) directly on the RCPv2 panel.
Integrating Tally directly via IP from Video Switchers
It is possible to integrate tally directly from a Video Switcher we have a Device Core for. In the case of a
ATEM Switcher the following steps needs to be taken to achieve Tally control on the camera:
-
Add an ATEM Device Core to the configuration
-
Add actions to the Hardware Component "Controller" like illustrated below (remember to set "Hold
Down"
It is also recommend to enable Tally feedback on the "ID Tally" bar via the following action:
SKAARHOJ DEVICE CORES
21