Panasonic AU-EVA1 Manual page 5

Hide thumbs Also See for AU-EVA1:

SKAARHOJ DEVICE CORES

Conﬁrm Connection

If the RCPv2 have come preconﬁgured with the Panasonic Conﬁguration or you have just successfully

downloaded the Firmware to the RCPv2, then it is ready to control the camera provided you have followed

the steps in the "Setting up Camera" section. It is important that the IP address you have set on the camera

matches the IP address of the Panasonic EVA1 Device Core.

Connection to the camera can be conﬁrmed from the Serial Monitor with the commands as shown below.

Check IP Addresses on SKAARHOJ Controller

If you have issues connecting to the camera it is recommend to conﬁrm that IP settings are correct. A way

to conﬁrm IP settings on the SKAARHOJ controller is using the Serial Monitor in the Firmware Application

and check IP settings in the boot up process.