Mitsubishi Electric MP-G10-AH Technical Manual page 10

4.6 Setting change
CAUTION
If the sewing machine is operated with the magnetic clamp settings, faults could occur.
Always change setting for the pneumatic type clamp.
(1) Points changed in setting details
Please change setting as follows.
*Refer to the clause of [14] Input/output setting mode and [15] Program mode of the
technical manual "Operation Panel" for detail.
Mode
Stitching
area
Presser
Presser
Home
position
Home
position
Home
position
Stitching
speed
Input/output
setting
Input/output
setting
Input/output
setting
Input/output
setting
Please ask the dealer about a password of Input/output setting mode.
Function
Label holder unit
name
ALC ON
WHY ON
FN 2
HPM JE
HPF ON
HPS ON
HIGH 2,300
4ms=ON
2ms=OFF
O4
66％
4ms=ON
2ms=OFF
O5
66％
O7 FN3
4ms=ON
2ms=OFF
O7
66％
Factory
setting
OF Stitching area limit is canceled
OF Pressing order of priority setting
1 Valid number of clamps setting
Home position return method when
－－
operation is halted
Prohibition
OF
position return operation
Presser state setting during home
OF
position return at power ON
2,800 Maximum speed
Set this when changing from the
2ms=ON
magnetic
4ms=OFF
pneumatic drive clamp
33％
[Set the chopping duty of Details
setting screen(2)]
Set this when changing from the
2ms=ON
magnetic
4ms=OFF
pneumatic drive clamp
33％ [Set the chopping duty of Details
setting screen(2)]
NO Set of Function code 3
Set this when changing from the
2ms=ON
magnetic
4ms=OFF
pneumatic drive clamp
33％ [Set the chopping duty of Details
setting screen(2)]
- 8 -
Remarks
of automatic home
drive clamp to
drive clamp to
drive clamp to
the
the
the