Mitsubishi Electric MP-G10-AH Technical Manual page 13

6.4 Creating the stitching data
Refer to the pattern in Fig. 1, and set points A to G
as shown in Fig. 3.
(1) Press on the operation panel's standard screen.
(2) Press the menu icon
Mode screen will open.
(3) Select
speed and stitch length.
Press , and then press
Mode screen will open.
(If there is no stitching data in the internal memory,
will not appear.)
(4) Input dry feed from the home position to point A with the arrow keys, and then press
(5) Next using the arrow keys, input point B
→ point E
(6) Press
. The Pattern Input
, and set the stitching data type,
. The Arrow Input
. Then, select
(reverse signal), and press
Fig. 2
Home position
→ point C
. The Code Input screen will open.
. The Arrow Input screen will reopen.
- 11 -
Reverse
Fig. 3
→ point D
.