Mitsubishi Electric MP-G10-AH Technical Manual page 12

6. Preparing to stitch labels
6.1 Stitching conditions
(1) Stitching size
Label holder（mm）
A
Max
100
(2) Stitching material thickness: 4mm or less
(3) Superimposed stitching length (Fig. 1 T dimension) ... 12mm or less
(4) Restrictions
Input the stitching data in a clockwise direction (direction of bold arrow in Fig. 1). The entire
periphery cannot be stitched when the data is input in the reverse direction
(counterclockwise direction).
The presser foot (cylindrical presser) and wiper mechanism cannot be used. Remove these
parts.
6.2 Preparing the label holder plate
Prepare the label holder plate with the following procedures to match the size of the label to
be sewn on.
(1) Remove the Fig. No. 138 round screw, and remove the Fig. No. 137 label plate mounting
block and Fig. No. 140 label holder plate.
(2) As shown in Fig. 2 on the next page, mark the label holder to indicate the size obtained by
subtracting the holder amount S from the stitching pattern position of the label to be sewn
on. (At this time, the holder amount S is set to the size of the needle or more. If set too
large, the stitches may miss the material.)
(3) Cut the plate along the marked lines using a cutter knife, fret saw or file, etc.
6.3 Drilling the work holder plate
A hole to allow the needle to escape at the home position, and holes to store and position
the label must be drilled on the work holder. Drill the plate with the following procedures.
(1) Install the parts removed when preparing the label holder plate at their original positions.
(2) Install the Fig. No. 147 work holder plate to the bottom of the Fig. No. 146 clamp frame
using the Fig. No. 148 pan-head screw.
(3) Depress the [Black] side of the 2-pedal foot switch, and lower the work holder.
(4) After placing a label under the label holder plate, depress the 1-pedal foot switch, and lower
the label holder. Check that the label is pressed at the correct position.
(5) Make marks at the moved home position and at the four corners of the label.
(6) Raise the label holder and work holder, and remove the work holder plate.
(7) As shown in Fig. 2, mark an escape hole for a φ10 or more needle at the home position,
and mark lines connecting the four corners of label.
(8) Cut out the plate along the marked lines using a cutter knife, fret saw or file, etc.
B
Min. Max Min.
35 80
Start of stitching
28
(Look ing from front of sewing machine)
- 10 -
End of stitching
Fig. 1