Change Axle Oil - Hitachi ZW 180-6 Operator's Manual

Wheel loader

Hide thumbs Also See for ZW 180-6:

Table of Contents

Change Axle Oil

--- every 2000 hours

WARNING: Take care about the following points.

 Starting repair work immediately after operation

may cause burns. Wait for the oil to cool before

starting any maintenance work.

 Lock the front and rear frames with the articulation

IMPORTANT: Do not use axle oils other than those listed

in the "Axle Oil".

Check Oil Level

1. Park the machine following the same procedures as

described on page 7-8 for preparation of inspection/

maintenance work.

2. Install articulation lock bar (1) to the front and rear of the

frame by following the procedures described on page

3. Clean the vicinity of oil level plug (2).

4. Remove oil level plug (2). Clean the tip of dipstick (3)

connected to oil level plug (2) with a clean cloth.

5. Make the plug lower surface contact to the axle seat

face. Oil level must be between marks H and L (4) on the

dipstick (3).

If necessary, add oil.