Introduction To Control Panel - Sharp PE-105-CS Manual

INTRODUCTION TO CONTROL PANEL

This indicates the program
you have chosen
AFTER START-UP
As soon as the bread maker is plugged to the power supply, a beep will be heard and "1 3:00"
appears in the display. But the two dots between the "3" and "00" don't flash constantly. The blue
backlight will turn off within 20 seconds when there's no action. "1" is the default program. "900g"
and "Medium" are default settings.
START/STOP
For starting, pausing and stopping the selected operation program.
To start a program, press the START/STOP button once. A short beep will be heard and the two
dots in the time display begin to flash and the program starts. All other buttons are deactivated
except the START/STOP button after a program has begun.
To stop the program, press the START/STOP button for more than 2 seconds, then a long beep
will be heard, it means that the program has been switched off.
PAUSE FUNCTION
After process starts up, you can press START/STOP button to interrupt at any time for less than 2
seconds, the operation will be paused but the setting will be saved, the outstanding time will be
flashed on the LCD panel.
Press START/STOP button again or within 10 min without pressing any other button, the program
will continue.
PROGRAM MENU
It is used to set different programs. Each time it is pressed (accompanied by a short beep) the
program will vary. Press the button discontinuously, the 12 menus will be cycled to show on the
LCD display. Select your desired program. The functions of 12 menus will be explained below.
Program 1: Basic
For white and mixed breads, it mainly consists of wheat flour or rye flour. The bread has a
compact consistency. You can adjust the bread brown by setting the COLOR button.
04
The operation time
for each program