Mitsubishi Electric G-50A Instruction Book page 19

NOTE:
• The display of setting contents is erased when shift to another screen.
• The following restrictions in the collective operation settings.
1. Temperature setting
The range that can be set falls within 19˚C ~ 28˚C /67˚F ~ 83˚F regardless of the operation mode.
2. Operation mode selection, fan speed selection, air direction, etc., can be collectively set regardless
of the functions of the unit. However, actual setting to a unit without functions cannot be performed.
To obtain the correct setting contents, refer to the respective group operation setting screens.
• When an M-NET remote controller is used, it must be properly registered to the group for the G-50A
unit to be able to prohibit its operation.
9 The collective operation setting initial screen is displayed.
REMOTE
PROHIBITION
0 Press the switch to set "REMOTE CONTROL [PROHIBIT]".
0
ARemote operation prohibition/permission display ("REMOTE CONTROL
[PROHIBIT]") is displayed with blinking.
BPress the
or
the indicated function area.
Press the ENTER switch one time to complete the collective prohibit set-
ting.
C The collective prohibit setting is executed.
It takes approximately 20 seconds.
D The collective prohibit setting is completed when the remote operation
prohibition/permission display is change to be light.
– 18 –
switch to display the "SET" in blinking display for