Mitsubishi Electric G-50A Instruction Book page 29

MENU
Additions
Group configuration date collective deletion
• Display "G00" in the group configuration setting screen and press the
delete the all group configuration data and all interlocked operation data.
NOTE:
• When this unit is set to the sub system controller by the function select, group registration can not be
made. However confirmation of the contents of group registration is possible.
• Simultaneously press the
perform group configuration setting. The initial setting menu screen is displayed. Select "1 GROUP
SETTING" on the setting menu screen, wait for the group setting screen to appear, and change the
setting.
Set all the units and controllers to be registered in the displayed group
number.
6Repeat operation 3 to 5 to set all groups managed by this controller.
7When all setting are completed, press the
NOTE:
8The following initial setting screen is displayed.
WED 15:29
When the interlocked operation settings are performed, refer to section
"5-5 Interlocked operation setting".
When the group name settings are performed, refer to section "5-6 Group
name setting".
When the user settings are performed, refer to section "5-7 User setting".
and
9When the necessary initial settings are complete, simultaneously press
the
When returned to the user operation screen, register processing for the
group configuration information and initial set up processing for each unit
and each controller is executed. (This process takes approximately 5 ~
7 minutes.)
• When there are M-NET local remote controllers in the
system, always be sure to set the local remote controller
address. The local remote controller will not operate if the
address setting is not performed.
However, when the local remote controller is an MA re-
mote controller (PAR-20/21MAA) or K-control type remote
controller, setting is not performed.
• If there is a K transmission converter is a component in the
system, do not perform the group configurations setting of
this controller for the K transmission converter.
keys on the user operation menu screen for 2 seconds to
and keys on the user operation menu screen for 2 seconds.
– 28 –
BACK
switch.
SCREEN
switch two times continuously to
DEL.