Mounting By Atw Units; Switching On And Checking - Mitsubishi Electric MELCloud Installation And Operation Manual

MELCLOUD
EXAMPLE OF MOUNTING ON THE SIDE OF THE INDOOR UNIT
Underside of indoor unit
Indoor unit
Corner flap
1. Place the power connecting cable in the space on the back of the unit, as shown in the illustration above.
2. Tuck in the cable and secure it.
NOTE!
►Verify that the connecting cable is not pinched between the installation plate and the wall or between
the indoor unit and the installation plate.
This could damage the cable and cause communication problems.
3.4.2

Mounting by ATW units

Cylinder unit
Cable clamp to
secure
Screw
3.5

Switching on and checking

After mounting the unit and checking installation, switch on the respective units and check whether the display on the
wi-fi adapter shows the corresponding pattern.
ERR
NET
MODE
UNIT
22 / Software information 2019
Side of indoor unit
Corner flap Indoor unit
Hydrobox
Cable clamp to
secure
Screw
OFF
OFF
OFF
ON
Connection to cylinder unit
150 150
Connection to hydrobox
150 150