1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Lower the cutting units.
4.
Shut off the engine and remove the key.
2
Disconnecting the Battery
No Parts Required
Procedure
1.
Open the hood
(Figure
2.
Rotate the battery disconnect switch to the O
position, refer to the Operator's Manual for your
machine.
1).
Figure 1
3
Removing the Side Panels
No Parts Required
Procedure
1.
Loosen the 2 knobs that secure the left and right
side panels to the machine
1. Side panel
2.
Remove the side panels from the machine
(Figure
2).
4
Removing the 28-V
Solenoid
No Parts Required
g251777
Procedure
Note:
Your machine may have up to 3 fuses on the
fuse bracket towards the rear end of the machine. For
FF
this procedure, remove the 28-V solenoid under the
fuse holder shown in
2
(Figure
Figure 2
Right side panel shown
2. Knobs
Figure
3.
2).
g251780