5
Installing the Contactor
Parts needed for this procedure:
1
Contactor
1
Contactor mount
1
Cable
4
Nut (1/4 inch)
2
Nut (5/16 inch)
2
Flange bolt
2
Carriage bolt
Procedure
1.
Use 2 carriage bolts and 2 nuts (1/4 inch) to
secure the contactor mount to the bracket
(Figure
7).
1. Carriage bolt
2. Contactor mount
2.
Use 2 flange bolts and 2 nuts (1/4 inch) to secure
the contactor to the contactor mount
Figure 7
3. Nut (1/4 inch)
(Figure
1. Contactor
2. Flange bolt
3.
Use a nut (5/16 inch) to secure the end of the
cable with the boot attached to the contactor
(Figure
9).
g282536
1. Nut (5/16 inch)
2. Cable
8).
4.
Use a nut (5/16 inch) to secure the other end
of the cable to the right post of the fuse holder
(Figure
9).
5.
Install the wire connector labeled
M
C
ASTER
the contactor
4
Figure 8
3. Nut (1/4 inch)
Figure 9
3. Nut (5/16 inch)
] to the left post at the top of
ONTACTOR
(Figure
10).
g282537
g282535
+ [28
COIL
V