LG CordZero A9 Owner's Manual page 26

NOTE
• When you replace the mop nozzle during
product operation, the product will operate in
only mop mode with suction OFF.
• Set the water adjustment button to the STOP
position when not using the appliance for an
extended period of time. Failure to do so may
result in product failure.
• If you use mop cleaning with suction OFF for
a long period of time, the safety device (motor
overheating prevention device) will operate,
stopping product operation, in order to protect
the mop nozzle. (Recommended duration of
use: 80 minutes) It is not a sign of malfunction.
Use the product after allowing the mop nozzle
to cool for 1 hour.
• Do not use this nozzle on PVC play mats
for children. Friction can cause the motor to
overheat.
• Do not slam down or throw the mop nozzle
onto the floor. Doing so may result in an injury
or product damage. Do not step on the mop
nozzle. Doing so may result in product damage.
Filling the Water Tank
1
Press the PUSH button a to remove the water
tank from the mop nozzle.
2
Open the water inlet cap b on the side of the
water tank and fill the tank with water using
the measuring cup c before MAX line d.
• Open only one water inlet cap to fill the
water. Opening both caps may cause the
water to flush.
• Do not put liquid other than water and hot
water in the water tank.
26
3
Close the water inlet cap tightly.
• If the water inlet cap is not closed properly,
water may leak.
4
Attach the water tank to the mop nozzle again.
• Insert the 2 tabs e at the front of the water
tank into the slots f on the top of the mop
nozzle. Press down at the center g to lock
the tank in place.
Attaching the Mop Pads
1
Wet both sides of the mop pads with water
then squeeze out any excess water before
attaching the pads.
• Attaching and using mop pads in a dry state
may affect the cleaning performance.
• Do not attach pads while they are dripping
wet.
2
Place the mop nozzle upside down on the
floor.
EN