LG CordZero A9 Owner's Manual page 28

Drying the Water Tank and Mop
Pads
Drying the Water Tank
When cleaning is completed, make sure to empty
the water and dry it before storing the mop nozzle.
Otherwise the water may be contaminated and
give off a bad smell.
1
Open the 2 water inlet caps a on the side
of the water tank and empty the water in the
water tank. Shake the water tank to remove
the remaining water.
2
Leave the 2 water inlet caps open and allow
the water tank to dry in a well-ventilated area
out of direct sunlight for at least 24 hours.
• Keep the water tank after water is
completely empty and dry. Moisture or
residual water in the tank may cause odour.
CAUTION
• Turn the water inlet caps to make sure they
remain open. If caps are closed and not
properly dried, it may cause odour.
• Do not remove the water inlet caps from the
water tank. Doing so could tear or damage the
rubber.
28
• Do not add detergent, vinegar or baking soda
to the water tank when washing. It is not easily
removed in the water tank, which may soil the
floor.
Drying the Mop Pads
After using the mop pads, hand wash them and
allow them to dry before storing them.
1
Separate the mop pads from the mop
attachment plate.
2
Hand wash the pads with a neutral detergent.
• Storing mop pads in a damp state can result
in an unpleasant odor. Set the pads in a
well-ventilated area out of direct sunlight for
at least 24 hours or until completely dry.
CAUTION
• After cleaning, wipe off any remaining water on
the water supply inlet a on the mop nozzle with
a soft cloth. The water could drip onto the floor
and damage it.
• Do not pull or stretch the rubber gasket on the
water supply inlet on the mop nozzle. Doing so
could tear or damage the rubber.
• Do not use as follows, as it may become
deformed.
− Do not use bleach or fabric softener when
washing the mop pads.
− Do not dry the pads in a clothes dryer.
− Do not boil the mop pad. The mop pad may
become deformed.
EN