Advertisement
Disassembly instructions
Remove a Power Supply
2. Remove I/O assemblies (varies according to configuration)
3. Remove 3.5" disk drives (12)
4. Remove 2.5" disk drive
5. Remove Storage processor
6. Remove Fans (6)
7. Remove DIMMs (varies according to configuration)
8. Disassemble SP:
a. Remove SLIC cage
b. Remove Fan cage
c. Remove SSD pcb
d. Remove PDB pcb
e. Remove DIB pcb
f. Remove SP pcb
This section contains the disassembly instructions for the product.
Before you begin
Note
You can replace one power supply while the system is running. As long as one
l
power supply is functional, you do not have to power down the system.
Have the replacement power supply unit on hand before removing an existing
l
power supply. With a running system, swap the old and new power supply within
five minutes to ensure proper air flow and to avoid overheating the system.
Only trained and qualified personnel should install or replace this equipment.
l
Always replace a failed power supply as soon as possible.
l
CAUTION
Whenever servicing parts in a running system, move slowly while removing,
inserting, or latching the new parts. This avoids creating strong vibrations in the
chassis, which might interfere with other running parts.
Procedure
1. Unlatch the bale securing the power supply power cord.
2. Disconnect the power cord from the power supply.
3. Press the orange unlocking tab to unlock the power supply unit (1).
WEEE Disassembly Instructions
Disassembly instructions
7
Advertisement
