Table of Contents
Advertisement
5.5
Force Setting the System
5.6
Unsetting the System
Siemens Building Technologies
Fire Safety & Security Products
The system can be forced to set while an alarm
zone is still open. This operation inhibits the open
zone and sets the system as normal.
If a user has the right to FORCE SET the system
and an alarm zone is open, when the FULLSET or
PARTSET option is selected, the Keypad buzzer
beeps and the first line of the display indicates the
open zone. The user is presented with the options
to QUIT (left soft key) or FORCE (right soft key).
QUIT: Selecting this option aborts the attempt to
set the system and returns the user to User
Programming.
FORCE: Selecting this option inhibits the open
zone and forces the system to set.
To UNSET a system:
1.
Enter a valid user code. The Keypad displays
a prompt to unset the system.
2.
To UNSET the system, press SELECT (right
soft key). The Keypad display indicates that
the system is unset on the bottom line of the
display for approximately 5 seconds. After this
time has elapsed, the bottom line is cleared.
3.
If the alarm has been activated, entering the
user code silences all bells and strobes and
the message PANEL DISARMED is displayed
on the Keypad for approximately 5 seconds.
4.
The source of the alarm condition is displayed
on the Keypad and the Alert LED flashes. The
Keypad continues to display the alert until the
alert is restored.
Setting, Unsetting, and Restoring the System
ZONE 1
QUIT
...FORCED SET?...
BACK
18/06/2008
SETTING 45 SECONDS
10/06/2008
SYSTEM FULLSET
...UNSET?...
EXIT
SYSTEM UNSET
PANEL DISARMED
ALARM ZONE 2
FIRST ZONE
OPEN
FORCE
SELECT
12:30
12:30
SELECT
13
09.2008
Advertisement
Table of Contents
