Table of Contents
Advertisement
5.8
Coded Restore
5.9
Using 868MHz Wireless Fob*
Siemens Building Technologies
Fire Safety & Security Products
The coded restore option is only available if the Security Grade of the system is set
to Grade 3 or Engineer Configure. It provides the user with the ability to restore
alert conditions that would normally only be available to the installation engineer.
To provide the user with this ability, it is necessary to protect this feature with a
code.
To perform a coded restore on the system:
1.
Ensure that the zone or fault that caused the alert condition has been
physically restored to its normal operating state.
2.
Contact the installer or the alarm receiving centre (ARC) before entering user
programming and selecting the coded restore feature in the menus option.
(Contact details should be available from the drop down label beneath the
Keypad.)
3.
Press SELECT on the Coded Restore option. A 6-digit reset code displays on
the top line.
4.
Provide 6-digit code to installer/ARC.
5.
Receive newly generated code from installer/ARC.
6.
Enter new code at the AUTH CODE prompt.
7.
Press SELECT.
The message SYSTEM RESTORED displays on the top line of the display.
NOTE
The coded restore feature can only be operated from the Keypad. This feature is not accessible from
the SPC5000/6000 web server browser.
*NOTE: Wireless features and devices will be available with a later market
package.
Setting, Unsetting, and Restoring the System
15
09.2008
Advertisement
Table of Contents
