Start Up The System - NEC SL1000 Getting Started Manual

SL1000 Getting Started Guide

2. Start Up the System

There are 2 types of start up method as below.
Start Up Method
Cold Start
Hot Start
2-1. Perform a Cold Start
This section describes the process for starting the system for the First Time or starting a system that you
want to erase the customer setting.
This will erase any customer configuration in the memory.
1. Set the power switch is OFF position.
2. Open the Sub-Cover of the SL1000 main KSU and make sure the Load button (S1) location on the
CPU card.
3 . Connect the AC power cord to the KSU, then plug the AC power cord Into an AC Outlet .
4 . Once the system has powered off, push in and hold the Load button(S1).
5. Turn the power switch to ON. Continue holding the Load button (S1) for approximately three second
or until Status LED (D5) starts flashing red.
6. Release the Load button.
7. When the system has completed reloading the software (about two minutes), the RUN LED is
flashing blue on the CPU card and the connected Multi-Line Telephone's display will show the Time
& Date and Extension Number.
Description
The factory setting data is loaded.
The customer setting data is loaded.
21
Purpose
• First time start up
• System Initialization
• System Reboot
Display Indication (Idle)