Test The System; Test The Sl1000 Multi-Line Telephones (Test Each Phone In Turn.); Test The Analog Telephones (Test Each Phone In Turn.) - NEC SL1000 Getting Started Manual

SL1000 Getting Started Guide
2-2. Perform a Hot Start
This section describes how to load system software from flash memory, and the customer data from
RAM memory.
Be sure that no calls are in progress otherwise they will be cut off.
1. Turn the system power off.
2. After it has powered off, turn the power switch back to ON and power on the system again. Wait
approximately two minutes.
3. When the system has completed reloading the software, the RUN LED is flashing blue on the
CPU card, and the connected Multi-Line Telephone's display will show the Time & Date and
Extension Number as Display Indication (Idle) on page 21.

Test the System

1. Test the SL1000 Multi-Line Telephones (Test each phone in turn.)

Procedure
1) Press the Speaker.
2) Check the connections
3) Plug phone into the ST
connection at the SL1000
unit.
4) Swap the phone

2. Test the Analog Telephones (Test each phone in turn.)

Procedure
1) Lift the handset.
2) Check the connections
3) Plug phone into the ST
connection at the SL1000
unit.
4) Swap the phone
If you hear system dialing tone the phone has initialized correctly, press
Speaker to clear.
If you do not hear dialing tone move to step 2).
Check the connections from the phone to the SL1000, ensure all 4 wires are
connected as shown in on page 15.
If you have used telephone cable and RJ11 sockets to extend the
connections.
Plug the phone directly into the ST connection at the SL1000 unit using the
line cord supplied with the system phone.
If the phone does not initialize correctly then move to step 4.
Try another SL1000 Multi-Line Telephone plugged directly into the ST
connection using the line cord supplied with the phone.
If you hear system dialing tone the phone has working correctly.
If you do not hear dialing tone move to step 2).
Check the connections from the phone to the SL1000, ensure both wires are
connected as shown in on page 15.
If you have used telephone cable and RJ11 sockets to extend the
connections.
Plug the phone directly into the ST connection at the SL1000 unit using the
RJ11 line cord (Ensure the line cord connections are correct).
If you do not hear dial tone when you lift the handset then move to step 4.
Try another Analog Telephone plugged directly into the ST connection using
the RJ11 line cord.
22
Action
Action