Stopping The Alarm/Activating The Snooze Function; Sleep Timer - Silvercrest SDR 15 A1 Operating Instructions Manual

16.2. Stopping the alarm/activating the
snooze function
 When the alarm sounds and the display flashes, you can end the
alarm by pressing either the
 Pressing the
countdown takes place on the display. After this, the alarm sounds
again.
The controller can be pressed several times to select the fol-
lowing snooze durations:
15 minutes, 30 minutes, 45 minutes, 60 minutes, 90 minutes or
120 minutes.
 The snooze function can be cancelled by briefly pressing either the
button or the
 Pressing the
will reset the snooze duration to 15 minutes.

16.3. Sleep timer

It is possible to programme a sleep timer on the device. After the set
time, the device automatically switches to standby mode.
 When the device is in use, press and hold the
button until the menu is shown on the display.
 Press the

 Then press the
 Press the

 Then press the
 Press the

duration. The following can be selected:
15 MINUTES
<
60 MINUTES
<
SLEEP OFF
<
controller activates the snooze function. A 15-minute
button.
SELECT
controller while the snooze function is active

/ button or turn the controller to select <System>.
SELECT
controller to select the system settings.

/ button or turn the controller to select <Sleep>.
SELECT
controller to select the sleep timer.

/ button or turn the controller to select the desired
30 MINUTES
>, <
90 MINUTES
>, <
> to disable the sleep timer.
button or the
MENU/INFO
45 MINUTES
>, <
120 MINUTES
>, <
button.
>,
> or
EN – 87
/