Table of Contents
Advertisement
Figure 5
1. Electrolyte
Important: Do not overfill the battery as this
allows electrolytes to overflow onto other parts
of the machine and cause severe corrosion and
deterioration.
6. Replace the vent caps.
7. Connect a 3 to 4 A battery charger to the battery posts
(Figure
6). Charge the battery at a rate of 3 to 4 A for 4
to 8 hours.
Figure 6
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
8. When the battery is charged, disconnect the charger
from the electrical outlet and the battery posts. Allow
the battery to sit for 5 to 10 minutes before proceeding
to the next step.
2
Installing the Battery
Parts needed for this procedure:
A/R
Petroleum jelly (not supplied)
Procedure
1. Slide the battery into the battery box with the terminals
facing rearward.
WARNING
Battery terminals or metal tools could short
against metal processor components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the tractor.
• Do not allow metal tools to short between
try terminals and metal parts of the tractor.
2. Attach the negative (black) cable to the negative (-)
terminal of the battery.
WARNING
Incorrect battery cable routing could damage
the processor and cables causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
3. Attach the positive (red) cable to the positive (+)
terminal.
4. Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion.
5. Install the battery cover and secure with the strap.
12
Advertisement
Table of Contents
