Toro ProCore Processor Operator's Manual page 15

Figure 12
1. Tie down or rope
2. Tow-arm-hitch plate
3. Back the tractor/aerator into position in front of the
core processor.
4. Remove the tie down or rope and lower the
tow-arm-hitch plate into the aerator hitch pivot
13).
Figure 13
1. Tow-arm-hitch plate
5. Align the hole in the tow arm hitch plate with the lower
holes in the aerator hitch pivot
6. Secure the tow-arm-hitch plate to the aerator hitch
pivot with a hitch pin and lynch pin.
7. Lower the aerator to the ground
8. Secure the pitch control link to the top holes in the
aerator hitch pivot and the frame hitch pivot with hitch
pins and lynch pins
3. Frame hitch pivot
2. Aerator hitch pivot
(Figure 14).
(Figure 14).
•
Connect the control link to the front holes in the
frame hitch pivot when operating ProCore 864 and
880 aerators.
•
Connect the control link to the rear holes in the
frame hitch pivot when operating a ProCore 660
aerator.
(Figure
1. Pitch-control link
2. Front mounting holes
(ProCore 880 and 864
Aerators)
9. Route the hydraulic hoses to the tractor and connect to
the quick couplers.
10. Make sure that the hydraulic hoses are properly
connected to the processor and the tractor.
11. Route the control harness to the tractor operators
position.
12. Secure the hydraulic hoses and the wire harness to the
tow-arms with cable ties.
Important: When turning the tractor to the right
or left, make sure that the hydraulic hoses or
control harness do not become disconnected or
damaged.
13. Operate the core processor and check the hydraulic
fluid level in the tow vehicle. Replenish as required.
14. Remove the storage pins from the front hole position
and insert them into the rear hole position during
operation
15
Figure 14
3. Rear mounting holes
(ProCore Aerator)
(Figure 15).