Table of Contents
Advertisement
Figure 44
1. Air-cleaner housing
2. Primary filter
3. Latch
4. Clean the inside of the air-cleaner cover with
compressed air.
5. Gently slide the primary filter out of the air-cleaner
housing
(Figure
44).
Note: Avoid knocking the filter into the side of the
housing.
6. Remove the safety filter only if you intend to replace it.
Important: Never attempt to clean the safety
filter. If the safety filter is dirty, then the primary
filter is damaged. Replace both filters.
7. Inspect the primary filter for damage by looking into
the filter while shining a bright light on the outside of
the filter.
Note: Holes in the filter appear as bright spots.
8. If the filter is damaged, discard it.
Servicing the Primary Air Filter
Service Interval: Every 200 hours
•
Replace the primary air filter if it is dirty, bent, or
damaged.
•
Do not clean the primary air filter.
Servicing the Safety Air Filter
Service Interval: Every 600 hours
Important: Never attempt to clean the safety air filter.
If the safety air filter is dirty, then the primary air filter is
damaged. Replace both filters.
Installing the Filters
Important: To prevent engine damage, always operate
the engine with both air filters and cover installed.
g018319
4. Air-cleaner cover
5. Safety filter
1. Check each filter for shipping damage. Do not
damaged filters.
2. Carefully slide the safety filter into the filter body
(Figure
44).
3. Carefully slide the primary filter over the safety filter
(Figure
44).
Note: Ensure that the primary filter is fully seated by
pushing on its outer rim while installing it.
Important: Do not press on the soft inside area
of the filter.
4. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the cover,
clean the cavity, and replace the outlet valve.
5. Install the air cleaner cover with the side indicated as
U
facing upward and secure the latch
P
6. Reset the indicator
Servicing the Engine Oil
Note: Change the oil more frequently when the operating
conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SG, SH, SJ or higher)
Crankcase Capacity: with filter, 2 L (67 oz)
Viscosity: Refer to
Figure 45
Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level is
at or below the A
mark on the dipstick, add oil to bring the
DD
oil level to the F
mark. Do not overfill. If the oil level is
ULL
between the F
and A
ULL
1. Park the machine on a level surface.
36
(Figure
Figure
43) if it shows red.
Figure 45
marks, no additional oil is needed.
DD
44).
Advertisement
Table of Contents
