Disconnecting The Core Processor From The Workman Vehicle - Toro ProCore Processor Operator's Manual

1. Latch handle
2. Latch-handle pin in the
unlocked position
B. Lift up on the latch handle
C. Slowly drive the vehicle forward until the hitch
assembly locks into place
Note: Lock the hitch assembly in the extended
position by moving the latch handle pin to the
forward (locked) position
1. Latch handle
9. Operate the core processor and check the hydraulic
fluid level in the vehicle. Replenish as required.
8
Disconnecting the Core
Processor from the Workman
Vehicle
No Parts Required
Procedure
1. Remove the storage pins from the rear hole position
(Figure 23).
Figure 21
3. Locked position
(Figure 22).
(Figure 22).
(Figure 21).
Figure 22
2. Hitch assembly
2. Slowly lower the processor until it comes to rest on the
rear roller and tires.
3. Install the storage pins in the front hole position
(Figure 23).
4. After the storage pins are installed, turn the tractor to
the O position.
FF
1. Storage pin
2. Front hole (core processor
disconnected from tow
vehicle)
5. Disconnect the hydraulic hoses.
6. Remove the remote control from the vehicle.
7. Wind the hoses and cable onto the harness mount for
storage.
8. To retract the tow hitch, lift up on the latch handle
and slowly back up the vehicle until the hitch assembly
locks into place
9. Lower the jack to the ground to stabilize the machine
Figure 24).
1. Jack
Important: Make sure that the tongue assembly
is retracted before disconnecting the processor
hitch tongue from the vehicle hitch.
10. Remove the lynch pin and hitch pin securing the
processor hitch tongue to the vehicle hitch.
18
Figure 23
3. Rear hole (core processor
connected to tow vehicle)
(Figure 22).
Figure 24