Repair / Troubleshooting; Test And Auxiliary Equipment - Siemens SCD 1897-M Replacements Of Parts

18" color tft monitor

Hide thumbs

Table Of Contents

Table of Contents

General Information

•

A laptop, etc. is not required; the adjustment is performed using the push-buttons on the

side of the unit and an on-screen menu.

•

The display can be controlled using RGB as well as S/W.

For configuration for S/W control, see the Instruction Manual.

•

For technical data, etc., see the Instruction Manual.

•

Video norm:

- The display detects the video norm that is present and sets itself automatically to this

norm.

- "New" norms that have not yet been set, can (must) be set. The next time this norm is

used, the display sets the norm again automatically.

- There is separate set of parameters in the display for each norm. This means that

each norm used must be set individually (also contrast / brightness).

•

Pixel drop-outs:

- Manufacturer-related pixel drop-outs are always possible; up to 15 pixels (light or

dark) are permissible.

•

Backlight control:

- The backlight is automatically adjusted. This means that the maximum contrast that

is set is retained as long as the control is not set to stop.

- When set to control stop, the maximum contrast is will be less with lower emission or

luminance. For the minimum values, see the chapter "System-related Adjustments".

If there is a drop below the "minimum value", replace the display.