Using The Microphone - Panasonic WX-LT350 Operating Instructions Manual

Using the microphone

POWER
ON
OFF
1
Power switch
Battery indicator
[PWR/MUTE] button
1
Turn on the power by pressing the power switch of the receiver.
The power indicator of the receiver lights green.
2
To turn on the microphone, press its [PWR/MUTE] button for 1 second or more.
The battery indicator of the microphone lights green or orange. To turn off the power, press
the button for 2 seconds or more. The battery indicator of the microphone turns off.
3
Adjust the volume.
Adjust the volume of the receiver with the audio volume controls. After adjusting the volume
level at the infrared receiver and any connected external devices, the speaker can make
fine adjustments, such as level differences. (☞ page 16, 17)
Turn off the power of the microphone and the infrared receiver after use.
Important:
• Do not assign more than one infrared wireless microphone to the same channel.
The noise may cause damage to the speaker, and an excessively loud volume may dam-
age your ears when the power switch of the microphone is turned on.
• While using the microphone, do not take the microphone close to the wireless powered
speaker (WX-LP100) (such as when adjusting the volume controls of the powered speak-
er).
Loud noises such as feedback may damage your hearing.
Note:
• Also read the operating instructions of the infrared receiver (WX-LR100, WX-LR100/A, WX-
LR100/B), the infrared receiver/amplifier (WX-LA20, WX-LA50), and the infrared wireless
powered speaker (WX-LP100).
Power indicator
IR SIGNAL
3
Audio volume controls
BATT
2
Infrared receiver
IR SIGNAL
Infrared Receiver WX–LR100/A
* The illustration shows
model WX-LR100/A.
WX-LT350
CHG
PWR
15