Gps Positioning; Indoor Mode - Epson SF-510 User Manual

GPS positioning

When you switch to the Measurement screen, the
product receives a signal from various satellites, and
identifies your GPS position.
c
Important:
Make sure you are outside with no obstructions
overhead, and try to keep the product as still as
possible.
1
Go to a location outside with no obstructions
overhead.
2
Press C on the Time screen to perform GPS
positioning.
When GPS positioning is complete, the
Measurement screen is displayed.
Setting up your SF-510/SF-710
When the Measurement screen is displayed, you can
start measuring.
See "Measuring your workouts" on page 29.
Skipping GPS positioning
If you do not want to use GPS features, or if GPS
positioning is taking too long, press C or D to highlight
Skip, then press A.
The product continues to search for a GPS signal, and
starts recording positional information when it
successfully synchronizes with a satellite. The route
you have travelled before the GPS has synchronized is
not recorded, but distance and pace data can still be
measured. The product will use the stride sensor until a
GPS connection is made.
See "Measurable items" on page 21.

Indoor mode

This function allows you to measure without
performing GPS positioning.
Your route is not recorded in Indoor mode. The
measurements recorded by your product are also
limited in Indoor mode.
See "Measurable items" on page 21.
19
Note:
It usually takes less than two minutes to complete
GPS positioning.
If it takes more than two minutes and Failed is
displayed, select Cancel, move to a different
location, and try again.