Table of Contents
Advertisement
Front bezel
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
To remove and reinstall the front bezel, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Release the three plastic tabs on the left side and pivot the front bezel outward to remove it from the
computer.
Figure 11. Removing the front bezel
3. To reinstall the front bezel, align the three plastic tabs on the right side of the front bezel with the
corresponding holes in the chassis. Then pivot the front bezel inwards until it snaps into position
on the left side.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 87.
Power button
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
To replace the power button, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Remove the front bezel. See "Front bezel" on page 59.
3. Locate the power button. See "Computer components" on page 5.
4. Disconnect the power button cable from the power button connector on the system board. See "Parts
on the system board" on page 5.
.
Chapter 7
Installing or replacing hardware
59
Advertisement
Table of Contents
