Cover Presence Switch - Lenovo ThinkStation P410 User Manual

Refer to the "Lithium coin cell battery notice" in the Safety, Warranty, and Setup Guide for information about
replacing and disposing of the battery.
To replace the battery, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Locate the battery. See "Parts on the system board" on page 5.
3. Remove the old battery.
Figure 39. Removing the old battery
4. Install a new battery.
Figure 40. Installing a new battery
5. Reinstall the computer cover and connect the cables. See "Completing the parts replacement" on
page 87.
Note: When the computer is turned on for the first time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
6. Turn on the computer and all attached devices.
7. Use the Setup Utility program to set the date, time, and any passwords. See "Using the Setup Utility
program" on page 33.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 87.

Cover presence switch

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
To replace the cover presence switch, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Locate the cover presence switch. See "Computer components" on page 5.
76
ThinkStation P410 User Guide