Mission Critical Geofence; Entering Mission Critical Geofence; Exiting Mission Critical Geofence; Trunking System Controls - Motorola APX 7000 User Manual

6875945M01-NL
Advanced Features
When the radio exits the Geofence area, your radio reverts to original channel or newly assigned
talkgroup. The radio display shows the new channel together with Voice Announcement to indicate the
changes. Voice Announcement of the new channel only works if that channel is configured with Voice
Announcement.
2.20.2

Mission Critical Geofence

This feature allows the radio to use the GPS receiver to determine radio location at frequent intervals.
This feature also allows the radio to evaluate if the radio is within the Geofence area in real time.
Check with your dealer or qualified technician to programme the geofence coordinates and actions.
2.20.3

Entering Mission Critical Geofence

When and where to use:
When the radio enters the predefined Geofence area, the radio displays <Geofence Alias> with
intelligent backlight and the user hears a Voice Announcement. Zone and channel alias of the
Geofence area is displayed. If the radio is set to manual, the user can choose either to proceed with
zone and channel change or cancel the change.
The radio then connects to the designated talkgroup. The radio displays the talkgroup alias and
dynamic regroup tone sounds. The transmit power level changes and the radio shows a direct text
message content without any user operation.
NOTICE:
Depending on how your radio is programmed, you may or may not be alerted by Voice
Announcement (VA), TMS display, Intelligent Backlight, and the Transmit Power Level. The
user will be alerted only if these indicators are configured in the radio. The VA can be
programmed to alert continuously or momentarily.
If Site Selectable Alert (SSA) is enabled, the radio mutes any alert that is received when
entering the Geofence area and unmutes when exiting.
2.20.4

Exiting Mission Critical Geofence

When and where to use:
When the radio exits the Geofence area, the radio reverts to the original transmit power level,
intelligent lighting, channel or newly assigned talkgroup. Voice announcement is cancelled or the user
hears a pre-programmed VA tone. The radio displays the new channel and a message is received to
indicate the changes.
2.21

Trunking System Controls

This chapters explains the trunking system control features in your radio.
2.21.1

Operating in Failsoft System

When and where to use:
The failsoft system ensures continuous radio communication during a trunked system failure. If a
trunking system fails completely, the radio goes into failsoft operation and automatically switches to its
failsoft channel.
124