Hitachi HF-W6500 45/40 Feature Manual page 151

8. SIMULATING THE HARDWARE STATUS
(2) Starting the simulation mode
To start the simulation mode, run the simulation mode start command (simrasstart
command) at the command prompt.
NOTE
・The simulation mode cannot be started from a remote desktop. Before you
start the simulation mode, other logged-on users must log off.
・If the RAS software has already detected hardware failure, the simulation
mode cannot be started. Remove the cause of the failure before using the
simulation mode.
1. Start Command Prompt.
You need to have administrator privileges to run the simulation mode start
command. Log on to the computer using an administrator account and start
Command Prompt.
If User Account Control (UAC) is enabled, start the command prompt as an
administrator according to "APPENDIX A RUNNING COMMAND PROMPT
AS AN ADMINISTRATOR".
2. At the command prompt, type the following, and then press Enter.
\%SystemDrive%\"Program Files"\HFWRAS\sim\simrasstart
3. You will receive the following message about exiting the simulation mode. Click
OK. If you click Cancel, the simulation mode does not start.
4. You will receive the following message to notify that the simulation mode starts.
Click OK. If you click Cancel, the simulation mode does not start.
8-4