Hitachi HF-W6500 45/40 Feature Manual page 159

8. SIMULATING THE HARDWARE STATUS
(4) Exiting the simulation mode
To exit the simulation mode, you need to restart this equipment.
For this reason, when the Simulation Tool window exits, this equipment is
automatically shut down in order to exit the simulation mode.
There is no limitation for how the equipment can restart in order to exit the simulation
mode. In the same way as normal mode, this equipment restarts in the following cases
(reasons).
・Shutdown is executed on the Start menu.
・A system shutdown API function such as the BSSysshut and ExitWindowsEx
functions is executed.
・The equipment is automatically shut down because fan failure, abnormal
temperature inside the chassis, or a remote shutdown signal input is detected.
・Ctrl+ALt+Del is pressed and using the power button at the lower right corner of the
screen, the equipment is shut down.
・A blue screen appears because, for example, the reset button is pressed.
・The power is forcibly turned off using the power switch.
・The End button or the Close button [×] in the Simulation Tool window is clicked.
・The Simulation Tool window is terminated with an error.
NOTE
・As explained above, the simulation mode exits when the equipment restarts
after automatic shutdown caused by simulated fan failure or abnormal
temperature inside the chassis. To start the simulation mode again, execute
the simulation mode start command.
When you execute shutdown or logoff, the following message is displayed to
notify that the simulation mode will exit and that the system will shut down.
・When a remote connection is used, shutdown process can be delayed when
shutdown is executed due to a reason listed above.
8-12