Toro Groundsmaster 3505-D Operator's Manual page 20

Figure 24
1. Fuel gauge
Hour Meter
The hour meter records the number of hours that
you operate the machine with the key switch in the
R position. Use these times for scheduling regular
UN
maintenance.
Engine-Coolant-Temperature
Warning Light
The temperature warning light glows if the engine
coolant temperature is too high. If the coolant
temperature rises another 10°, the engine shuts off
(Figure 23).
Glow-Plug-Indicator Light
The glow-plug-indicator light glows when the glow
plugs are operating (Figure
Oil-Pressure Warning Light
The oil-pressure warning light glows if the engine-oil
pressure drops below a safe level
oil pressure is low, shut off the engine and determine
the cause. Repair the engine-oil system before you
start the engine again.
Lift-Lock Lever
Use the lift-lock lever to secure the lift switch
23), to the -
RAISE DECK
maintenance on the cutting unit or when transporting
between mowing locations.
2. Seat-adjustment lever
23).
(Figure 23). If the
(Figure
position, when performing
Mow/Transport Slide
Using your heel, move the mow/transport slide to the
left to transport, and to the right to mow
Note:
The cutting units operate only in the mow
position.
Important:
The mow speed is set at the factory
to 9.7 km/h (6 mph). You can increase or decrease
the mow speed by adjusting the speed-stop screw
(Figure 25).
g031598
1. Speed-stop screw
Indicator Slot
The indicator slot in the operator platform indicates
when the cutting units are in the center position
(Figure 22).
Throttle
Move the throttle forward to increase the engine
speed and rearward to decrease the engine speed
(Figure 23).
Cutting-Unit-Drive Switch
The cutting-unit-drive switch has 2 positions: E
and D
ISENGAGE
solenoid valve on the valve bank to drive the cutting
units (Figure 23).
Cutting-Unit Shift Lever
To lower the cutting units to the ground, move the
cutting-unit shift lever forward. To raise the cutting
units, pull the shift lever rearward to the R
(Figure 23).
Note:
The cutting units do not drop unless the engine
is running.
Move the lever to the right or left to move the cutting
units in the same direction.
Note:
Do this only when the cutting units are raised or
if they are on the ground and the machine is moving.
20
Figure 25
. The rocker switch operates a
(Figure 22).
g031596
NGAGE
position
AISE