Engine Maintenance; Engine Safety; Servicing The Air Cleaner - Toro Groundsmaster 3505-D Operator's Manual

Figure 43
•
2 (per cutting unit) rear roller bearings
Figure 44
Note:
Ensure that the grease groove in each
roller mount aligns with the grease hole in each
end of the roller shaft. To help align the groove
and hole, there is also an alignment mark on an
end of the roller shaft.
Important:
Do not lubricate the Sidewinder
cross tube. The bearing blocks are
self-lubricated.

Engine Maintenance

Engine Safety

•
Shut off the engine and remove the key before
checking the oil or adding oil to the crankcase.
•
Do not change the governor speed or overspeed
the engine.
g008906

Servicing the Air Cleaner

Check the air-cleaner body for damage that could
(Figure 44) cause an air leak and replace it if it is damaged. Check
the entire intake system for leaks, damage, or loose
hose clamps. Also, inspect the rubber intake-hose
connections at the air cleaner and turbocharger to
ensure that the connections are complete.
Ensure that the cover is seated correctly and seals
with the air-cleaner body.
Servicing the Air-Cleaner Cover
Service Interval: Every 50 hours—Remove the
g195309
Check the air-cleaner body for damage which could
cause an air leak. Replace a damaged air cleaner
body.
Clean the air-cleaner cover
40
air-cleaner cover and clean out the
debris. Do not remove the filter.
(Figure 45).