Toro Groundsmaster 3505-D Operator's Manual page 52

Figure 63
1. Hydraulic-tank cap
3. Remove the hydraulic-tank cap
4. Remove the dipstick from the filler neck and
wipe it with a clean rag.
5. Insert the dipstick into the filler neck, then
remove it and check the fluid level.
Note:
The fluid level should be within 6 mm
(1/4 inch) of the mark on the dipstick.
6. If the level is low, add the appropriate fluid to
raise the level to the F
7. Install the dipstick and cap onto the filler neck.
Changing the Hydraulic Fluid
Service Interval: Every 2,000 hours—If you
are using the recommended
hydraulic fluid, change the
hydraulic fluid.
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
change the hydraulic fluid.
Hydraulic Fluid Capacity: 13.2 L (3.5 US gallons)
If the fluid becomes contaminated, contact your local
Toro distributor to flush the system. Contaminated
fluid looks milky or black.
1. Turn the engine off and raise the hood.
2. Disconnect the hydraulic line or remove the
hydraulic filter and let the hydraulic fluid flow into
a drain pan (Figure 66
g031641
(Figure 63).
mark.
ULL
and Figure 64).
1. Hydraulic line
3. Install the hydraulic line when the hydraulic fluid
stops draining
4. Fill the reservoir
13.2 L (3.5 US gallons) of hydraulic fluid; refer
to Hydraulic Fluid Specifications (page 51)
Checking the Hydraulic Fluid Level (page
Important:
Use only the hydraulic fluids
specified. Other fluids could damage the
system.
1. Hydraulic-tank cap
5. Install the reservoir cap.
6. Start the engine.
7. Use all the hydraulic controls to distribute the
hydraulic fluid throughout the system, check for
leaks, then shut off the engine.
8. Check the fluid level and add enough to raise
the level to the F
Note:
Do not overfill.
52
Figure 64
(Figure 64).
(Figure 65) with approximately
Figure 65
mark on the dipstick.
ULL
g031643
and
51).
g031641