Toro Groundsmaster 3505-D Operator's Manual page 7

1. Height-of-cut settings
Note:
This machine complies with the industry standard
stability test in the static lateral and longitudinal tests with the
maximum recommended slope indicated on the decal. Review the
instructions for operating the machine on slopes in the Operator's
Manual as well as the conditions in which you would operate the
machine to determine whether you can operate the machine in the
conditions on that day and at that site. Changes in the terrain can
result in a change in slope operation for the machine. If possible,
keep the cutting units lowered to the ground while operating the
machine on slopes. Raising the cutting units while operating on
slopes can cause the machine to become unstable.
1. Tipping hazard—do not drive across slopes greater than
17°.
121-3598
121–3627
decal121-3598
7
decal121-3627