Panasonic YD-500GP5 Operating Instructions Manual page 32

The functions that support the configuration of the welding machine are as follows
Function
Select networking
mode and set
networking
parameters
Modify the sampling
frequency of the
welder
Set connection
parameters
Server certificate and
URL
Configurable parameters
Ethernet、WIFI、GPRS
0.2s、0.5s、1s
Welder password, welder
address, communication
method
Set up the certificate
required to communicate
with the device server
Connection
Function Description
●Both Ethernet and GPRS networking
modes are enabled by default
●The two networking methods of Ethernet
and WIFI cannot be enabled at the same
time
●The two networking methods of Ethernet
and WIFI cannot be enabled at the same
time
●If GPRS is disabled, iWeldCloud function
will be invalid
●If you choose to disable the LAN, the two
networking methods of Ethernet and WIFI
will be invalid, and the iWeld software
cannot be connected.
●Set the real-time data upload frequency of
the welding machine
●The welding machine password needs to
be consistent with the PLC special machine
password
●The welding machine address needs to be
consistent with the
address in the PLC
●There are two communication methods:
RS485 and RS422
URL and certificate must be configured at
the same time. Improper configuration may
cause iWeldCloud function failure
28
Note
The
version only
has Ethernet.
The
version only
has 1s.
welding machine
Only use this
function
when
device server
changes
export
export
the